Place your decal where you want
Vehicle Windows, Vehicle Body Surfaces, Motorcycles, Mopeds, Bicycles,
Helmets, Tractors, Trailers, Toolboxes, ATV's, Jet Skis, Surfboards,
Snowmobiles, Snowboards, Skateboards, Drums, Guitars, Mirrors, Laptop Cases,
Desktop Computer Towers, Boats, Hard Hats, Walls, Smooth Painted Surfaces,
Store Windows, Plastic Boxes, Printers, Lockers, Doors, Laminate Surfaces or
just about any surface that is smooth and clean!
The surface temperature should be about room temperature or cool to the
touch. Do not apply decal to a hot or
extremely cold surface. Application
surface MUST BE completely clean and
free of any dust, oils, wax or other debris.
If you are using Windex or another ammonia-based cleaner to clean the
surface, dry the area completely before applying the decal. The ammonia interferes with the
adhesive. Any surface contamination such
as bad bodywork, rust, dust or other debris will show through and spoil your
final result. We will not be held responsible for you not correctly following these
Placing Decal: All Decals come with tape on them, when you
are ready to place Decal peel taping back and the Decal with be stuck to
it. Placing decal to the area you want
by putting a small section of the tape down on the area. Once you are sure slowly start lowering the
decal down and using a credit card, ruler, or hand to smooth it down. Once placed completely rub with credit card,
ruler, or hand on all edges and body of the Decal and then slow peel tape
back. If you notice that the Decal is
still stuck to the tape put tape back down and rub again until it stays on the
surface you have placed it.
We are not
responsible for damages due to you not following directions given to you
before purchase (listed above) and paper instructions provided in your shipment.
JL Custom Vinyl Store